Trusted Fort Myers Roofing handles roof ventilation installation in Fort Myers, FL, for homes and commercial properties in Tice, Palmona Park and Page Park. We install ridge vents, soffit intake, off-ridge vents, and solar attic fans that move hot, damp air out of the attic and keep your roof from cooking from the inside.
The most common problem we find is a home with plenty of exhaust at the top but little to no intake at the soffits, which is a setup that’s surprisingly common across Florida. When that happens, attic temperatures can climb past 150°F, baking the shingles and drying out the underlayment years early. We calculate net free vent area using the 1:300 balanced ratio allowed by Florida code, clear or add soffit vents for intake and match them with ridge exhaust, since a Florida attic study found a balanced system ran more than 30 degrees cooler than an unbalanced one.
Most ventilation upgrades are done in a single day, and they fit easily into a reroof if you’re planning one. A new ridge vent typically runs about $300 to $650, while adding soffit vents usually costs around $315 to $465, and we’ll give you a free written estimate after checking your attic.
Every ventilation system we install is backed by our 5-year written workmanship warranty. We’ll go over the details with you first, so you know your attic and roof are protected for the long haul.
Serving Southwest Florida since 2001, Trusted Fort Myers Roofing brings decades of experience to residential roofing projects, including roof installation, repair, and replacement.
Trusted Fort Myers Roofing is BBB-accredited, licensed, and insured. We use quality roofing materials and follow proper installation practices.
We provide free roofing estimates so you can review the expected costs, material options, and work involved before replacing your roof.
We offer a 5-year written workmanship warranty on qualifying roof replacement work, with coverage subject to the warranty's terms and conditions.
GAF President's Club Award (2019)
Licensed and Insured


The homeowners couldn’t figure out why their upstairs bedrooms stayed stuffy even with the AC running, until we checked the attic and found a ridge vent up top with almost no intake below, since most of the soffit was solid vinyl. Trusted Fort Myers Roofing cut new openings along the overhang and installed screened, louvered soffit vents, then added rafter baffles inside so the insulation wouldn’t block the fresh air coming in. With intake and exhaust finally balanced, air now flows from the soffits out through the ridge, and the attic runs noticeably cooler on summer afternoons.
Final Cost: $1,250
Turnaround Time: 1 day


This home’s standing seam metal roof looked great from the street, but the attic underneath had soffit intake and almost nowhere for hot air to escape, so heat and moisture kept building up under the panels. Trusted Fort Myers Roofing added low-profile exhaust vents near the ridge, cutting each opening cleanly between the seams so the panel ribs stayed intact. We sealed every vent base with butyl tape and fastened it with stainless screws and sealing washers, giving the attic a steady way to breathe without any risk of leaks around the metal.
Final Cost: $1,450
Turnaround Time: 1 day


The homeowners had an older gable vent that barely moved any air, and with a low-slope metal roof overhead, the attic was holding heat well into the evening. Trusted Fort Myers Roofing replaced the old vent with a gable-mounted exhaust fan, wiring it to a thermostat and humidistat so it only runs when the attic actually needs it. Before turning it on, we added soffit intake along the eaves so the fan pulls fresh outside air instead of cooled air from the house, and the aluminum shutters close automatically when the fan shuts off to keep wind-driven rain out.
Final Cost: $850
Turnaround Time: 1 day
Trusted Fort Myers Roofing
Need a roof repair, replacement, or new installation? We're here to help. Get honest advice, clear pricing, and a free roofing estimate for your home.
Hotter than outside, but not by much. A properly ventilated attic usually runs about 10 to 20°F above the outdoor temperature, or around 110 to 115°F on a 95°F day. If it’s 40 to 50°F hotter than outside on a summer afternoon, the ventilation isn’t keeping up.
Yes. Attic heat above 150°F can break down shingles and rot decking from underneath, cutting a 20-year roof’s realistic life to around 13 years. Most of the time, unbalanced ventilation is the cause.
Code calls for at least 1 square foot of net free vent area for every 150 square feet of attic space, and that can drop to 1 for every 300 square feet with a balanced intake and exhaust system. We measure your attic and do the math before recommending anything.
No. The number one rule of balanced ventilation is that there should never be more exhaust than intake. Extra exhaust without enough intake just strains the system instead of cooling the attic.
It can help. A Florida Solar Energy Center review found that standard 1:300 ventilation with soffit and ridge vents produced a 32% reduction in attic heat flux. Less heat soaking into the ceiling means the AC doesn’t have to work as hard.
There’s still a fix. Trusted Fort Myers Roofing uses fascia-mounted or low-profile edge intake vents made for homes with no soffits, so the attic gets the fresh air it needs without changing the look of the roofline.